Topic Review
Water-Related Issues in Bhutan
Water for hydropower in Bhutan has been in focus as compared to that allocated for irrigation, industries, and environmental demand. The demand for water in Bhutan has also increased in the last decade due to population increase, changes in lifestyle, and economic advancements through tourism and hydropower projects.
  • 3.8K
  • 28 Apr 2021
Topic Review
Water-Gas Shift Reaction
The water-gas shift reaction (WGSR) describes the reaction of carbon monoxide and water vapor to form carbon dioxide and hydrogen: The water gas shift reaction was discovered by Italian physicist Felice Fontana in 1780. It was not until much later that the industrial value of this reaction was realized. Before the early 20th century, hydrogen was obtained by reacting steam under high pressure with iron to produce iron, iron oxide and hydrogen. With the development of industrial processes that required hydrogen, such as the Haber–Bosch ammonia synthesis, a less expensive and more efficient method of hydrogen production was needed. As a resolution to this problem, the WGSR was combined with the gasification of coal to produce a pure hydrogen product. As the idea of hydrogen economy gains popularity, the focus on hydrogen as a replacement fuel source for hydrocarbons is increasing.
  • 4.9K
  • 22 Nov 2022
Topic Review
Water-Energy Nexus in Africa
The operationalization of the Water-Energy Nexus in the water supply is gaining  a lot of attention among water utilities, water regulators and stakeholders in the water sector. This is due to the growing body of evidence on the potential benefits of exploration of potential energy savings in the supply of water services, as the largest controllable operational input with short payback periods on investment. As population grows, high urbanization and the demand for water services increases especially in Africa, water utilities are faced with the challenges of meeting the current demand and expansion of services. However, there is paucity in the assessment of energy input for water supply and energy use is not considered as a key performance indicator for water utilities. Yet, accrued benefits from scrutinizing energy input in the water sector provides potential benefits of savings, revenue recovery and expansion of water services.
  • 636
  • 20 Oct 2020
Topic Review
Water-Driven Music
Water-driven music technology has been one of the primary sources of human leisure from prehistoric times up until the present. Water powered, along with air pressure organs, have been used throughout history. One of them was an organ of fountains located inside a formal garden. 
  • 2.1K
  • 22 Feb 2021
Topic Review
Water-Based Liquid Scintillators
Monolithic optical detectors, either water–Cherenkov detectors or liquid scintillator detectors, are a well-established technique in neutrino physics. Using water-based liquid scintillators (WbLS) is an approach that exploits Cherenkov and scintillation signals simultaneously; i.e., water is loaded with 1% to 10% liquid scintillator. 
  • 590
  • 04 Jan 2023
Topic Review
Water Yam (Dioscorea alata)
Anthracnose disease caused by a fungus Colletotrichum gloeosporioides is the primary cause of yield loss in water yam (Dioscorea alata), the widely cultivated species of yam. Resistance to yam anthracnose disease (YAD) is a prime target in breeding initiatives to develop durable-resistant cultivars for sustainable management of the disease in water yam cultivation.
  • 1.3K
  • 24 Feb 2022
Topic Review
Water Well
A water well is an excavation or structure created in the ground by digging, driving, boring, or drilling to access groundwater in underground aquifers. The well water is drawn by a pump, or using containers, such as buckets, that are raised mechanically or by hand. Wells were first constructed at least eight thousand years ago and historically vary in construction from a simple scoop in the sediment of a dry watercourse to the qanats of Iran, and the stepwells and sakiehs of India. Placing a lining in the well shaft helps create stability, and linings of wood or wickerwork date back at least as far as the Iron Age. Wells have traditionally been sunk by hand digging, as is the case in rural areas of the developing world. These wells are inexpensive and low-tech as they use mostly manual labour, and the structure can be lined with brick or stone as the excavation proceeds. A more modern method called caissoning uses pre-cast reinforced concrete well rings that are lowered into the hole. Driven wells can be created in unconsolidated material with a well hole structure, which consists of a hardened drive point and a screen of perforated pipe, after which a pump is installed to collect the water. Deeper wells can be excavated by hand drilling methods or machine drilling, using a bit in a borehole. Drilled wells are usually cased with a factory-made pipe composed of steel or plastic. Drilled wells can access water at much greater depths than dug wells. Two broad classes of well are shallow or unconfined wells completed within the uppermost saturated aquifer at that location, and deep or confined wells, sunk through an impermeable stratum into an aquifer beneath. A collector well can be constructed adjacent to a freshwater lake or stream with water percolating through the intervening material. The site of a well can be selected by a hydrogeologist, or groundwater surveyor. Water may be pumped or hand drawn. Impurities from the surface can easily reach shallow sources and contamination of the supply by pathogens or chemical contaminants needs to be avoided. Well water typically contains more minerals in solution than surface water and may require treatment before being potable. Soil salination can occur as the water table falls and the surrounding soil begins to dry out. Another environmental problem is the potential for methane to seep into the water.
  • 2.5K
  • 27 Oct 2022
Topic Review
Water Treatment Using Functional Composites
Due to its low cost, biosorption technology has been extensively carried out to treat heavy metal-laden wastewater using biosorbents. The studies on heavy metal biosorption mechanisms and the simulation of mathematical modeling on the biosorption process have enhanced scientific understanding about the binding between target metal cations and the functional group on different surfaces of biomasses as a biosorbent.
  • 458
  • 21 Feb 2023
Topic Review
Water Treatment Residues and Methanogenic Activity in Wastewater-Sludge
The effect of adding alum water treatment residues (WTR) on the methanogenic activity in the digestion of primary domestic wastewater sludge was evaluated through laboratory experiments in sedimentation columns, using total suspended solids (TSS) concentrations from 0.37 to 1.23 g/L. The addition of WTR to primary clarifiers can benefit its effluent water quality in terms of colour, turbidity, chemical oxygen demand (COD), and TSS. However, the presence of WTR can negatively influence the production of methane gas during organic sludge digestion in primary clarifiers, for concentrations of TSS between 14.43 and 25.23 g/L and of VSS between 10.2 and 11.85 g/L. The activity of the Methanothrix sp., curved bacilli, methanococci, and Methanosarcina sp. decreases considerably after 16 days of anaerobic digestion, and methane production seems to only be associated with fluorescent methanogenic bacilli.
  • 842
  • 17 Mar 2022
Topic Review
Water Treatment Plant Sludge Dewatering
Using geotextile tubes as dewatering technology may significantly contribute to sustainable treatment of sludge generated in different industries, such as the water industry. This is an economical alternative for dewatering sludge from a Water Treatment Plant (WTP), which prevents sludge from being directly deposited in water bodies and makes it possible to then transfer the sludge to landfills. 
  • 1.2K
  • 27 Oct 2020
  • Page
  • of
  • 5494
ScholarVision Creations