1. Open chromatin regions.
2. Cis-regulatory elements. | DNase I hypersensitive sites sequencing (DNase-seq). [14] | DNase I digested fragments are extracted using biotin-streptavidin complex. | 1. High signal-to-noise ratio compared to FAIRE-seq.
2. No prior knowledge of locus-specific sequences, primers, or epitope tags is required.
3. Efficiently maps non-coding regions proximal to genes. | 1. DNase I sequence-specific cleavage biases may determine cleavage patterns at the predicted transcription factor (TF) binding sites or footprints. This complicates correctly assessing true transcription factor binding at open chromatin. [15]
2. Requires high number of cells (ideally >= 1 M cells) [14] and a high sequencing depth.
3. Maps relatively low distal regulatory sites compared to formaldehyde-assisted isolation of regulatory elements with sequencing (FAIRE-seq). [16] | Single-cell (sc)-DNase-seq. [17] |
1. Nucleosome positioning.
2. DNA-bound protein binding sites. | Micrococcal nuclease digestion of chromatin followed by sequencing (MNase-seq) [18],
(alternative: nucleosome occupancy and methylome sequencing (NOME-seq). [19] | Cross-linking to covalently link proteins to the DNA, followed by micrococcal nuclease digestion to remove free DNA. | 1. MNase-seq can map DNA-protein binding for both histone and non-histone proteins.
2. Indirectly maps chromatin accessibility.
3. The digested fraction of accessible chromatin can be repurposed for chromatin immunoprecipitation-based assays (Native-ChIP). | 1. Requires a broad range of sequencing read-out (25 bps to 150 bps) to capture both sub-nucleosome and nucleosome fragments. [20]
2. High dependency on optimized MNase enzyme digestion for reproducibility between experiments.
3. MNase enzyme produces AT cleavage bias that needs bioinformatic corrections.
4. Requires large number of cellular input (ideally >= 1 M cells). | scMNase-seq, and scNOME-seq. [21,22,23,24] |
1. Open chromatin.
2. Cis-regulatory elements.
3. Nucleosome distribution. | Assay for transposase-accessible chromatin coupled to sequencing (ATAC-seq). [25] | Tn5 transposases-based cutting and tagging of open chromatin. | 1. Low input (ideally <= 50,000 cells)
2. Short and easy to use protocol.
3. Very high signal-to-noise ratio compared to other chromatin accessibility techniques. | 1. Tn5 sequence insertion bias can lead to mapping and/or TF footprinting biases and needs bioinformatic corrections.
2. Mitochondrial contamination of reads (although Omni-ATAC [26] is optimized for lower mitochondrial reads). | Flow cytometry-based approaches and single cell/nucleus ATAC-seq. [27,28,29,30,31,32] |
1. Protein-DNA interactions.
2. Histone post-translational modification. | Chromatin immunoprecipitation with sequencing (ChIP-seq). [33,34,35] | Formaldehyde crosslinked (X-ChIP) or micrococcal digested fragments (Native-ChIP) followed by immunoprecipitation. | 1. Gold standard to map genome-wide, direct DNA-protein interactions.
2. Single-nucleotide resolution (compared to ChIP-qPCR and ChIP-chip).
3. An ultra-low-input micrococcal nuclease-based native ChIP (ULI-NChIP) can profile genome-wide binding sites of histone proteins with as few as 1000 cells. [36] | 1. Cross-linking and sonication steps (X-ChIP) can lead to high background noise, requiring higher cellular input for optimal signal-to-noise ratio. [33]
2. Relies on the availability and quality of specific antibodies and can suffer from epitope masking due to cross-linking of fragments (X-ChIP).
3. Requires appropriate control experiments to minimize detection of false-positive protein-DNA binding sites. | sc-ChIP-seq [37] |
1. Protein-DNA interactions.
2. Histone post-translational modification. | ChIP with exonuclease (ChIP-exo) [38],
Cleavage under targets & release using nuclease (CUT&RUN)
[39],
Cleavage under targets and tagmentation. (CUT&TAG) [40] | ChIP-exo: X-ChIP immunoprecipitated fragments followed by additional λ exonuclease digestion step.
CUT&RUN: MNase tethered protein A, targeting specific antibody against the protein of interest.
CUT&TAG:
Tn5 transposase and protein A fusion protein, targeting antibody against the protein of interest. | 1.ChIP-exo: with an extra exonuclease treatment, it can remove unbound and non-specific DNA, providing higher signal-to-noise ratio over ChIP-seq. [38]
2. CUT&RUN:
(i) Uses enzyme-tethering to avoid cross-linking and fragmentation of DNA that greatly reduces the background noise, and epitope masking, making it lower input over ChIP.
(ii) It has been validated to map H3K27me3-marked heterochromatin regions. [39]
(iii)Use of enzyme-tethering also maps local environment of binding sites, making it suitable to also detect long-range interactions of the protein.
3. CUT&TAG:
(i) Requires the least number of cells compared to alternatives (ideally >= 100 cells) and can be performed at single-cell level. [40]
(ii) It bypasses cross-linking (compared to ChIP) and library preparation step (compared to ChIP and CUT&RUN).
(iii) More sensitive, easier workflow and cost-effective compared to CUT&RUN and alternatives | 1. ChIP-exo: High number of enzymatic steps in ChIP-exo makes it technically challenging and suffers from epitope masking, similar to ChIP.
2.CUT&RUN:
(i) Calcium-activated MNase enzyme digestion of chromatin needs to be carefully optimized, to prevent over/under digestion of accessible chromatin. It also relies on antibody quality, like ChIP.
(ii) Like X-ChIP, CUT&RUN cannot distinguish direct from indirect 3D contacts. [39]
(iii) Requires higher number of cells relative to CUT&TAG (ideally >= 100,000 but can be performed with as low as 1000 cells). [39]
3. CUT&TAG:
(i) A potential limitation is antibody-validation, since mapping certain protein-DNA interactions can be more efficient after cross-linking.
(ii) Tn5 enzyme biases may confound detection of proteins at heterochromatin regions, since Tn5 preferentially tags accessible chromatin | CUT&TAG
[40] |
3. Chromatin loops and 3D interactions. | Chromosome Conformation Capture
3C [41],
4C [42],
5C [43], and
Hi-C. [44] | Formaldehyde cross-linking to covalently link physically interacting chromatin fragments. | 3C/4C/5C: these progressive modifications can map increasingly more chromatin conformations, i.e., one-to-one, one-to-many, and many-to-many epigenetic features, respectively.
Hi-C (all-to-all):
1. An unbiased approach that maps genome-wide 3D chromatin conformations.
2. Long-range interactions several mega-base pairs away and high-resolution inter-chromosomal contacts can also be mapped.
3. Low cellular input over 3C/4C (ideally >= 1 M cells).
Easy-Hi-C: a biotin-free strategy, more sensitive and requires relatively lower cell input over Hi-C (ideally >= 50,000 cells). [45] | 3C/4C/5C:
1. Maps to a limited resolution and genomic distances of interacting regions.
2. Need priori-defined regions of interests.
3. Cannot resolve long-range contacts by haplotypes (maternal/paternal) of the chromosomes.
4. Requires relatively higher number of cells (ideally >= 10M cells).
Hi-C:
(i) It cannot detect chromatin contacts with cell-type specificity and cannot detect functional relevance of the chromatin loops.
(ii) Some proximity-ligation events can remain undetected due to low efficiency of biotin incorporation at ligation junctions. [45] | Flow cytometry-based approaches [46,47],
sc-Hi-C-seq
[48,49],
sci-Hi-C-seq [50,51], Dip-C [52] |
4. Protein-bound 3D interactions | Chromatin interaction analysis by paired-end tag sequencing (ChIA-PET) [53],
HiChIP [54],
and
Proximity ligation-assisted ChIP-seq (PLAC-seq). [55] | Formaldehyde cross-linking, followed by antibody-based immunoprecipitation of protein-bound chromatin interactions. | ChIA-PET, HiChIP & PLAC-seq: Can illustrate regulatory roles of 3D chromatin interactions.
HiChIP & PLAC-seq: Higher signal-to-noise ratio and significantly lower cell input compared to ChIA-PET. | ChIA-PET:
1. Low sensitivity in detecting 3D interactions and can have false-positive reads by non-specific antibody binding.
2. Requires very high number of cellular input (ideally >= 100 M cells) [54,56] and high sequencing depth.
3. Ligation of DNA linkers to chromatin fragments can also lead to self-ligation of linkers and false-positive read-outs.
ChIA-PET, HiChIP, and PLAC-seq:
They all require a priori of target protein of interest and need bioinformatic correction for biases introduced by: ChIP procedure, different fragment lengths, and restriction enzymes cut-site biases.
HiChIP and PLAC-seq also require high cell-number (ideally >= 1 M cells). | Flow
cytometry approach [55,57], and
multiplex chromatin
interaction analysis via droplet-based and barcode-linked sequencing (ChIA-Drop) [58] |