1. Gynogenesis in Agricultural Crops
Haploid regeneration by means of unpollinated female gametophytes is one of the most commonly used alternatives in species where androgenesis has not been effective; this method is called haploid gynogenesis or haploid parthenogenesis. The term gynogenic haploid regeneration is used for all haploid induction methods in which a female gametophyte is used as the origin of the haploid cells, regardless of whether it is a pseudofertilization process or not; therefore, there are four variants: (a) in vitro culture of unfertilized ovaries or ovules
[1], (b) pollination with pollen irradiated with cobalt-60 (
60Co)
[2][3], (c) wide hybridization
[2] and (d) in vivo haploid inducers
[3][4].
1.1. In Vitro Culture of Ovaries or Ovules
In the case of self-pollinated species, in vitro culture of unfertilized female gametes is achieved by culturing flower buds prior to anthesis, while in male-sterile or self-incompatible plants it is performed at any stage of ovule development, since they show a favorable response to gynogenic induction
[5]. This technique is successfully employed in species of the genus
Allium, where it is the main technique to derive DHs
[6]. For example, Panahandeh et al.
[7] achieved a gynogenic induction range of 5 to 12% by culturing unpollinated flower buds of
Allium hirtifolium Boiss., which allowed callus formation with a success rate of 20%, of which the efficiency of obtaining haploid plants was 70 to 77%. This technique is also viable in both wild and improved species of the genus
Gentiana L. spp.
[8][9][10]. Although the results obtained were promising in both species mentioned, the authors agree that it is necessary to continue with the establishment of efficient protocols because the average response in obtaining haploid plants does not exceed 5% (
Table 2).
Table 2. Examples of protocols used for successful haploid induction mediated in vitro culture of unfertilized ovaries or ovules.
1.2. Irradiated Pollen
Irradiated pollen allows the development of haploid embryos by fertilizing an ovule with mature pollen whose genetic material is inactive, i.e., it is capable of inducing cell divisions in the ovule and the normal development of the embryo
[2]. There are many favorable examples involving the use of irradiated pollen in different vegetable and fruit species in which androgenesis was not an option (
Table 3).
Table 3. Examples of successful haploid induction methods by induced parthenogenesis by irradiated pollen in recalcitrant species.
Thus, Hooghvorst et al.
[3] and Kurtar et al.
[19] reported that in cucurbits, a family containing crops of high economic value such as pumpkin, melon and cucumber, pollination with γ-ray-irradiated pollen is the most efficient method to induce haploidy because it has not been possible to take advantage of androgenesis in these crops. In
Cucumis melo L., pollen irradiated with 250 Gys of
137Cs was more effective compared to in vitro culture of unpollinated ovules
[16]. Likewise, Nasertorabi et al.
[17] obtained 48 Cucumis melo L. plants induced from embryos obtained with pollen irradiated with 550 Gys of
60Co, of which 94% were haploid.
In citrus, this technique has proven to be very useful to obtain haploid plants with high value for breeding. For example, Wang et al.
[14] were able to induce haploid plants in
Citrus grandis L.
Osbeck by irradiating pollen with γ-rays with doses lower than 500 Gys and in vitro culture of immature embryos. Likewise, Jedidi et al.
[18], by irradiating pollen at 250 Gys with γ-rays, obtained seven seedlings that were used to generate homozygous lines in
Citrus reticulata Blanco.
1.3. Wide Hybridization
The third variant of gynogenesis consists of interspecific crosses, through which it is possible to induce the formation of haploid embryos due to the fertilization of an ovule with pollen from a distant species, allowing double fertilization. However, cell divisions in the zygote eliminate the chromosomes of the male parent
[2][20]. Thus, Santra et al.
[21] published an efficient protocol to obtain completely homozygous lines in only two years by wide hybridization to obtain DHs from wheat pollinated with maize pollen.
Although wide hybridization is most commonly used in cereals, in recent years its application in leafy vegetables has been shown to have acceptable results in the induction of haploid plants (
Table 4). For example, Piosik et al.
[22] carried out distant hybridization of
Lactuca sativa L. with
Helianthus annus L. and
Helianthus tuberosus L., with which they established an effective methodology to induce haploidy in lettuce. In addition, Wei et al.
[23] obtained haploid offspring by embryo rescue and subsequent duplication of chromosomal material with colchicine using a commercial variety of
Brassica oleracea var.
alboglabra as the male parent and a variety of
Brassica rapa var.
parachinensis as the female parent. Similarly, haploid plants were obtained by crossing
Brassica rapa × Brassica oleracea and in vitro culture of immature embryos
[24].
Table 4. Summary of haploid induction methodologies by wide hybridization.
1.4. In Vivo Haploid Induction
In the past decade, methodologies applied to induce in vivo haploidy to accelerate the production of double haploid lines have been developed for several target crops
[3][28]. These methodologies take advantage of the specific gene expressions that regulate the formation of maternal haploids (
Table 5). In maize, the generation of in vivo haploid inducer lines of maternal haploidy via the expression of the genes
MATL [29],
NLD [30] and
ZmPLA1 has been possible
[31]. In wheat, the genetic edition of the gen
MTL permitted to observe that the alleles
mtl-AD,
mtl-BD and
mtl-ABD were effective to generate inducer lines from self-pollinated and cross-pollinated progenies; its rate of success ranged between 7.8% and 15.6%
[32]. However, these genes do not work in dicot species
[33]. On the other hand, the haploid induction from aneuploidy is possible via CRISPR/Cas9 mutation of the
CENH3 gene in both monocot and dicot crops
[3][28]. These two methodologies are very promising and are used in cereals because they have been more efficient than the in vitro methods.
Table 5. Summary of haploid induction reports via in vivo haploid inducers.
In contrast, the conservation of the
DMP genes in dicot species opens up the possibility to apply this haploidy induction system
[33]. From this starting point, protocols for some horticultural crops have been developed. In
Brassica napus L.,
bnaDMP mutation could induce amphihaploidy
[36][37]. In
Nicotiana tabacum L., it was reported that the simultaneous
MtDMP1,
MtDMP2 and
MtDMP3 mutations can trigger maternal haploidy at rates from 1.52% to 1.75%
[38]. In contrast, the inactivation of the
MtDMP8 and
MtDMP9 alleles in
Medicago truncatula Gaertn would facilitate in vivo maternal haploid induction at a rate from 0.29% to 0.82% in mutant progeny
[39]. Despite these results, the use of
DMP genes is not very frequent because there are not transformation systems (CRISPR/Cas9) or TILLING populations in major crops
[3][37].
2. Gynogenesis in Tomato
Due to the few successful results obtained by androgenesis for haploidy induction and the formation of doubled haploids in tomato, some research groups have sought alternatives to achieve this goal. The options employed are variants of gynogenesis: wide hybridization, unfertilized ovule culture and irradiated pollen
[42]; and haploid inducers/CRISPR/Cas9
[40]; however, it is not yet fully known what these could mean for the breeding of this crop.
2.1. Wide Hybridization
Wild species phylogenetically related to tomato are commonly used for crop improvement to incorporate alleles of interest into crop breeding programs, most notably
S. pimpinellifolium [43],
S. arcanum Peralta
[44],
S. sitiens I. M. Johnst
[45],
S. pinnelli L.
[46],
S. chilense (Dunal) Reiche
[47],
S. neorickii D. M. Spooner, G. J. Anderson & R. K. Jansen
[48],
S. habrochaites S. Knapp & D. M. Spooner
[49] and
S. sisymbriifolium Lam.
[50].
The general use of wide crosses in this species is not only performed to induce haploidy, as some studies have attempted to apply them to generate DHs (
Table 4). For example,
S. sisybriifolium pollen was used unsuccessfully to induce haploids
[26]. In contrast,
S. sisybriifolium pollen allowed obtaining haploid and di-haploid genotypes of maternal origin.
Even though only ~10% of embryos were rescued and only two plants were generated, the results suggest that it may be a viable alternative; however, the author suggests that the procedure needs to be modified to improve results
[27].
2.2. Unfertilized Ovule Culture
Few attempts have been made to obtain haploid tomato plants by in vitro culture of unfertilized ovules (
Table 2). In tomato, this objective was not possible despite the fact that ovules have a variable response to different culture media
[12]. Moreover, Zhao et al.
[51] designed a very efficient in vitro protocol with which they isolated, from a single ovary in tomato, between 100 and 150 ovules with which they were able to induce gynogenic callus; despite this, they were unsuccessful in regenerating haploid plants.
2.3. Irradiated Pollen
Regarding the use of irradiated pollen in tomato, the work carried out is limited, although the results are promising (
Table 3). Thus, Nishiyama et al.
[52] reported that
S. pimpinellifolium pollen maintains its germination capacity and that it is possible to generate fruits with some seeds with doses of 2000 to 7000 Gys of X-rays. In addition, Nishiyama et al.
[53], when applying between 100 and 1100 Gys in increments of 100 Grays with X and γ radiation to
S. pimpinellifolium pollen, found that it has the same effect on germination and fruit set, with a pollen germination capacity of less than 50% with doses higher than 300 Gys. These studies suggest the possibility of obtaining tomato fruits and seeds from irradiated pollen, although the doses used did not allow inactivating the genetic material of the microspore and inducing haploid parthenogenesis. However, the success of this technique obtained in other crops allows us to assume that it is essential to determine the median lethal dose (LD
50), which could vary according to the genotype and species
[1][54].
For this methodology to be used in tomato breeding programs for haploidy induction, the optimum dose for the inactivation of genetic material in pollen must be determined. In recent years, Akbudak et al.
[55] irradiated pollen from different tomato hybrids with doses of 100, 200, 300 and 400 Gys of γ-rays without obtaining fruit in any treatment although radiation doses higher than 200 Gys correspond to LD50. Likewise, Bal et al.
[42] mentioned their own unpublished work on haploidy induction in this crop using irradiated pollen, where 1000 Gys caused the loss of viability and germination capacity of the pollen; however, with 800 Gys, fruits were generated, which were aborted in the early stages of development.
2.4. In Vivo Haploid Inducers
In tomato, the use of CRISPR/Cas9 has been applied to achieve objectives such as introgression breeding
[56], plant architecture, fruit development and ripening
[57], herbicide-resistance
[58], leaf development
[59] and ToBRFV-resistant tomato
[60]. This suggests that it is possible to generate protocols to use the
DMP and
CENH3 genes that regulate the gynogenesis to facilitate the generation of maternal haploid inducer males, as reported in maize
[29][30][31] and wheat
[32]. Thus, Zhong et al.
[40] obtained
sldmp tomato mutants using CRISPR/Cas9, with a rate of 1.9% for haploidy induction. Likewise, KEYGENE N. V. (Wageningen, Netherlands) has a patent for a methodology to generate haploids via GFP-tailswap disruption that by editing the
CENH3 gene produces 0.5–2.3% of haploids
[41]. These achievements produced by genetic edition show the potential of the in vivo haploid inducers to obtain DH lines in tomato and other recalcitrant crops.
This entry is adapted from the peer-reviewed paper 10.3390/plants11121595