1. Radical Addition
1.1. Acyl Addition to Alkenes
In 2019, the Wu and Tung group demonstrated a groundbreaking example of acylation/cyclization of Michael acceptors with acyl radicals derived from acyl oxime esters
1 with C–C bond cleavage. Hence, cyclobutyl ketone derivatives
4 and acylated oxindoles
6 were obtained using
fac-Ir(ppy)
3 as a photosensitizer at room temperature (
Scheme 21)
[40][1]. The mechanism studies show that the acyl oxime esters
1 are first reduced by a Ir
III catalyst under 3 W blue-light conditions, and then the acyl radicals
7 are produced by C–C bond cleavage. On the one hand, the acyl radical
7 is captured by styrene
3 and oxidized by Ir
IV to remove a proton to produce enone
8, which is sensitized by Ir
III* to further react with another styrene
3 to lead to cross [2 + 2] cyclization and obtain acylated cyclobutanones derivatives
4. Alternatively, acyl radicals
7 could also add to the C–C double bond of the acrylamides
5 to afford structurally useful acylation oxindole skeletons
6.
Scheme 21. Visible-light-induced radical acylation/cyclization of acyl oxime esters with olefins.
In the same year, this group reported a novel three-component difunctionalization reaction of acyl oxime esters, olefins and alkane nitriles, which generated a series of
β-carbonyl imides
12 with excellent yields (
Scheme 32)
[41][2]. The isotope tracking experiment and control experiments revealed the efficient intermolecular reorganization of oxime esters into styrene with the aid of solvent exchange. A possible reaction mechanism is shown in
Scheme 32. First, the acyloxime esters
1 are cleaved to nitrile, carboxylate anions
13 and acyl radicals
7 by a single electron transfer (SET) process with the excited state Ir
III*, which is generated from Ir
III under blue-light irradiation. Then, a SET occurs between intermediate
14, which is produced by the addition of an acyl radical
7 to the olefin
3 and Ir
IV to complete the cycle of catalyst Ir and produce the carbocation
15. The intermediate
16, produced by the nucleophilic attack of nitrile to cation
15, undergoes a Mumm rearrangement with carboxylate anions
13 to obtain the amide products
12.
Scheme 32. Visible-light-induced radical difunctionalization of acyl oxime esters with styrenes and nitriles.
A photocatalytic hydroacylation of alkenes with acyl oximes for the synthesis of valuable ketones was developed by Yang et al. (
Scheme 43)
[42][3]. When CF
3-attached styrenes were used, a E1cB-type fluoride elimination pathway was proposed for the obtainment of the 1,1-difluoroolefin products
19. In this difunctionalization reaction, the triphenylphosphine radical cation generated by the reaction of the excited catalyst Ir
III* with triphenyl phosphine combines with the nucleophile acyl oximes
1 to obtain the phosphorus radical intermediate
20. The N–O bond cleavage of the intermediate
20 gives the iminyl radical
21 via
β-scission. The imino radical
21 undergoes C–C bond scission to give acyl radical
7 and a molecule of acetonitrile. The acyl radical is added to alkene
17 and reduced by Ir
II to get the carbanion intermediate
23, with the following protonation to generate the desired product
18.
Scheme 43. Visible-light-induced hydroacylation of acyl oximes with alkenes.
In 2021, Sun and co-workers developed a distinctive carbonylation approach using Ir and DIPEA to access
γ-keto acids
24 and cyanocarboxylic acids
25 (
Scheme 54)
[43][4]. Mechanistically, this reaction involves the photocatalytic radical addition of acyl radicals and cyanoalkyl radicals to aromatic olefins and then carbon dioxide capture. The valuable dicarbofunctionalization tolerates a wide range of cyclic ketoxime substrates; however, only aliphatic acyl oxime esters proceed smoothly to afford corresponding
γ-keto ester products.
Scheme 54. Visible-light photoredox-catalyzed dicarbofunctionalization of styrenes with oxime esters and CO2.
Larionov’s group described a
N-heterocyclic, carbene-photocatalyzed, three-component regioselective 1,2-diacylation of alkenes, using acyl oxime esters and aldehydes as two different acylating agents (
Scheme 65)
[44][5]. In particular, the authors demonstrated the mechanism by density functional theory (DFT) and time-dependent-DFT (TD-DFT), where an EDA intermediate is probably formed in the diacylation, which initiates photoexcitation to mediate charge transfer. The EDA intermediate
33, formed by the complexation of the Breslow intermediate
32 with the acyl oxime ester
1, is excited under light conditions and subsequently cleaved to remove BzO
- and acetonitrile to give the intermediate
34 and acyl radical
7. The intermediate
14 produced by the addition of the acyl radical
7 to the olefin
3 couples with the intermediate
34 and then decomposes to a diketone product
30 and carbene
31.
Scheme 65. N-heterocyclic carbene-photocatalyzed 1,2-diacylation of alkenes with acyl oxime esters and aldehydes.
Liu and Huang’s group reported an intriguing route to 3-acyl-substituted chroman-4-one derivatives
36, which involves SET reduction of acyl oxime esters
1 by
fac-Ir(ppy)
3 under thermal and light conditions (
Scheme 76)
[45][6]. In this functionalization reaction, the acyl radical generated from the acyl oxime ester first adds to the carbon double bond of the 2-allyloxy benzaldehydes
35, followed by intramolecular cyclization and 1,2-HAT (hydrogen atom transfer) to obtain the alcohol radical intermediate
40. Finally, SET oxidation by Ir
IV and deprotonation occur to obtain the target products
36.
Scheme 76. Visible-light-induced acylation of acyl oxime esters with 2-allyloxy benzaldehydes.
Another acylation/cyclization strategy mediated by a photocatalytic nitrogen-centered radical of acyl oxime esters
1 with activated acrylamides
42 was reported by Liu and Huang’s group (
Scheme 87)
[46][7]. The authors screened a variety of acyl oximes with different leaving groups, such as 4-CF
3C
6H
4CO, 4-NO
2C
6H
4CO, C
6F
5CO, CF
3CO, etc., and achieved up to 95% yields with 58 synthetic examples of acylated transformations. The fragmentation of one C–C bond and one N–O bond and the formulation of two new C–C bonds were carried out in one-pot conditions with a low catalyst loading (1 mol%). This protocol represents a simple and green road for the synthesis of acylated indolo/benzimidazo-[2,1,a]isoquinolin-6(5
H) ones.
Scheme 87. Visible-light-induced acylation of acyl oxime esters with reactive olefins.
Most recently, the same group uncovered a new acylation reaction of acyl oxime esters with activated
N-sulfonyl acrylamides
48, with a broad substrate scope and good functional group compatibility (
Scheme 98)
[47][8]. This method provides an effective nitrogen center-mediated approach for the generation of acyl radical intermediates to access acylated oxindole
6. This acylation transformation proceeds through a normal Smiles rearrangement process that involves cascade intramolecular
ispo-cyclization (
50), de-SO
2 (
51) and re-cyclization (
52).
Scheme 98. Visible-light-induced acylation of acyl oxime esters with N-(arylsulfonyl)acrylamides.
1.2. Acyl Addition to Alkynes
The heterocyclic skeleton presents in commercial drugs and many naturally occurring compounds; thus, the development of convenient and environmentally friendly methods for the construction of this structural motif is an important and promising research field
[48,49,50][9][10][11]. Alkynes with specific substituents, such as alkyne amides
[51[12][13][14],
52,53], N-propylindoles
[54,55[15][16][17],
56], alkyne esters
[57[18][19],
58], alkyne amines
[59,60[20][21][22],
61], etc., are often used as radical acceptors to construct potential heterocyclic compounds by tandem cyclization. Recently, Liu and Zhou have independently developed a multitude of innovative photocatalytic, nitrogen-centered, radical-mediated acylation strategies of reactive alkynes using acyl oxime esters as acyl sources (
Scheme 109)
[37,39,62,63][23][24][25][26].
Scheme 109. Visible-light photoredox-catalyzed acylation of alkynes with acyl oxime esters.
Liu’s group pioneered a radical addition strategy of acyl oxime esters
1 with activated alkynes
54 to construct a series of 3-acylated spiro [4,5]trienones derivatives
55 [37][23]. The acyl radical generated by the C–C bond breakage of acyl oxime esters attacks the carbon–carbon triple bond of propiolamides
54 to give the radical intermediate
62. The intermediate
62 undergoes intramolecular
ispo-cyclization and is oxidized to carbocations
64 by Ir
IV, followed by the combination with hydroxide anion produced in water to obtain the intermediate
65. Finally, a methoxy anion and hydrogen ion are removed to obtain the expected trienone product
55.
Subsequently, Liu’s group developed two pragmatic acylation strategies using
N-propynylindoles
56 [63][26] and alkynoates
58 [62][25] under photoexcitation conditions. A large quantity of acylated pyrrolo[1,2-
a]indole
57 and coumarin
59 derivatives were constructed, and interestingly, both the alkanoyl and aryl groups were well adapted. These studies further developed the application of acyl oxime esters and were of great importance for the development of free radical synthetic chemistry.
Comparably, Zhou’s group has achieved a series of constructions of 3-acyl quinoline skeleton
61 under photocatalytic conditions with
N-propargyl aromatic amines
60 as radical acceptors
[39][24]. The mechanism of this acylation reaction states that acyl radicals add to the carbon–carbon triple bond of
N-propargyl aromatic amines
60 for intramolecular cyclization and then proceed to dehydroarylation to give the final quinoline product
61.
2. Radical Cross-Couple
Recently, the development of the photoredox/palladium-catalyzed C-H acylation of 2-arylpyridines
78 with acyl oxime esters
1 using
fac-Ir(ppy)
3 as a photosensitizer was reported by the Chen group (
Scheme 110)
[64][27]. In order to thoroughly study the reaction mechanism, the author carried out some control experiments, including the radical clock reaction using benzocycloketoxime ester
80 with ethene-1,1-diyldibenzene under standard conditions and TEMPO as a radical inhibitor to test the activity of the reaction. The generation of the target product
83 and the detection of the free radical capture product
84 by the HRMS indicate that this acylation reaction contains a free radical mechanism.
Scheme 110. Photoredox/palladium-catalyzed C-H acylation of 2-arylpyridines with acyl oxime esters.
In addition to the above acyl oxime esters, Wu’s group reported the benzyl oxime esters
85 with the same reaction mode, i.e., a single electron transfer followed by carbon–carbon bond cleavage to produce the corresponding radical (
Scheme 121)
[38][28]. The resulting benzyl radicals
91 are further oxidized to benzyl carbocation
92, which are then coupled with O and N-nucleophilic reagents to access the target benzyl ethers
88 and benzylamines
89. This benzylation strategy well tolerates various functional groups under mild conditions, where a wide range of nucleophilic substrates, such as primary and secondary alcohols, amines and even H
2O, worked smoothly.
Scheme 121. Visible-light-induced coupling of benzyl oxime esters with O- and N- nucleophiles.