Downstream Processing of Virus Filter

Downstream Processing of Virus Filter: Comparison

Please note this is a comparison between Version 2 by Conner Chen and Version 3 by Conner Chen.

Virus filtration is a single-use, size-based separation process in which the contaminating virus particles are retained while the therapeutic molecules pass through the membrane pores. Virus filtration is routinely used as part of the overall virus clearance strategy. Compromised performance of virus filters due to membrane fouling, low throughput and reduced viral clearance, is of considerable industrial significance and is frequently a major challenge.

process development
virus filtration

1. Introduction

A virus filtration step is frequently included to provide a robust size-based clearance of both enveloped and non-enveloped viruses during the manufacture of mammalian cell-derived biotherapeutics, such as monoclonal antibodies (mAbs) and Fc-fusion proteins ^[1][2]. Before approval of new therapeutics, regulatory agencies such as the US Food and Drug Administration (FDA) require validation of adequate virus clearance ^[3]. Consequently, unit operations are added to the purification train to ensure high levels of virus clearance ^[4]. Virus filtration uses large pore size ultrafiltration membranes to retain any contaminating virus particles while recovering the virus-free product in the permeate. Unlike conventional ultrafiltration operations, the performance criteria for virus filters are far stricter ^[5]. Typically, around 95% product recovery is required while maintaining at least 1000 fold (3 log reduction) virus clearance ^[2].

Table 1 lists a range of mammalian cell-derived biotherapeutics that have been approved by the Food and Drug Administration (FDA) over the last three decades. The monoclonal antibody industry sector grossed over USD 154 billion in 2020 ^[6][7]. Mammalian cells used for expression of recent FDA-approved monoclonal antibodies include Chinese Hamster Ovary (CHO) cells and murine myeloma cells (Sp2/0, NS0), among others ^[6][8].

Drug Classification	Examples	First Approval by FDA	Manufacturer
Monoclonal antibodies	Pembrolizumab	2014	Merck
	Nivolumab	2014	Bristol Myers Squibb
	Aducanumab	2021	Biogen
	Avelumab	2017

^[2]. These particles are typically around 80–100 nm in size. Clearance can be achieved by inactivation and/or physical removal from the process stream ^[15][16][17]. During purification, manufacturers of mammalian cell-derived biotherapeutics must demonstrate that the process will yield a final product containing no more than one virus particle in a million doses. Estimates of the number of virus particles in a single dose equivalent from the bioreactor could be as high as 10¹⁰–10¹⁵ retrovirus-like particles per mL ^[2]. Removal of adventitious viruses such as parvovirus is also required. These much smaller viruses are around 20 nm in size. In the past, filters targeted for retrovirus and parvovirus removal were included in the purification train ^[3]. Recent studies show that virus clearance filters designed to provide clearance of smaller parvovirus can be used to clear much larger retroviruses simultaneously ^[18]. Table 2 shows some viruses that are employed for validation studies in biomanufacturing. The enveloped retroviruses are typically larger than the non-enveloped parvoviruses. Consequently, virus filtration membranes that are validated for removal of parvovirus are also effective at clearing retrovirus from the product.

Table 2. Some common viruses used for validation studies in biomanufacturing ^[19].

Name of Virus	Diameter (nm)
Animal parvoviruses (non-enveloped DNA viruses, bovine, canine, or porcine)	18–24
Poliovirus (picornavirus, non-enveloped RNA virus)	25–30
Encephalomyocarditis virus (EMC, picornavirus, non-enveloped RNA virus)	25–30
EMD Serono
Feline calicivirus (calicivirus, non-enveloped RNA virus)	35–39	Omalizumab	2003	Genentech
Bovine viral diarrhea virus (BVDV, flavivirus, enveloped RNA virus)	40–60	Adalimumab	2002	Abbvie
Tezepelumab-ekko	2021	Amgen/AstraZeneca
SV40 (simian vacuolating virus 40, polyomavirus, non-enveloped DNA virus)	45–55	Fc-fusion proteins	Abatacept	2021	Bristol Myers Squibb
Aflibercept	2011		Regeneron
Alefacept	2003		Biogen
Etanercept	1998		Amgen

Sindbis virus (togavirus, enveloped RNA virus)	60–70
Reovirus (non-enveloped RNA virus)	60–80
Herpes simplex virus (HSV, Herpesviridae, enveloped DNA virus)	150	Rilonacept	2008	Regeneron
Cytokines	Darbepoetin alfa	2011	Amgen
	Interferon beta-1a	2003	Biogen
	Epoetin alfa	2011	Amgen
Enzymes	Agalsidase beta	2003	Genzyme
	Human DNase	1993	Genentech
	Laronidase	2003	Biomarin
	Tenecteplase	2000	Genentech
Hormones	Choriogonadotropin alfa	2000	EMD Serono
	Follitropin alfa	2004	EMD Serono
	Osteogenic protein-1	2001	Stryker Biotech
	Thyrotropin alfa	1998	Genzyme

Table 1. Examples of approved Chinese Hamster Ovary (CHO) cell-derived biotherapeutics. Non-exhaustive list compiled from publicly available resources (https://www.accessdata.fda.gov/scripts/cder/daf/index.cfm?event=BasicSearch.process), US Food and Drug Administration, (last accessed 10 January 2022), European Medicines Agency ^[9].

Virus filtration is different from typical pressure-driven membrane filtration processes, as the filter is designed to obtain very high levels of removal of potential virus contaminants. Further, as it is impractical to validate that there is zero carryover of any trapped virus particles, reuse of the virus filter is impossible. Consequently, these are single-use devices. Virus filters are typically run in normal flow (dead end) mode, rather than tangential flow mode used for protein ultrafiltration, since normal flow is less complex and requires only a single pump.

2. Downstream Processing

2.1. Platform Processes

Biopharmaceutical manufacturing processes can be divided into two main processing trains: upstream cell culture operations and downstream purification processes. Various bioreactor configurations are used to produce the cells that express the product of interest (mAbs, enzymes, Fc-fusion proteins, or hormones). Removing particulate matter such as cells and cell debris occurs at the interface between upstream and downstream unit operations. These bioreactor clarification operations are sometimes referred to as midstream processes ^[10][11]. Figure 1 is a typical ‘platform’ process for the downstream purification of monoclonal antibodies. The first unit operation is typically an affinity chromatography capture step using protein A (resin-based chromatography) ^[12]. Affinity interaction is a specific interaction based on both the topological fit and a combination of electrostatic, hydrophobic, and hydrogen-bonding interactions ^[13]. Antibody elution from the protein A column is performed at low pH, making it very convenient to include a low pH hold for virus inactivation.

Figure 1. Downstream purification of mammalian cell-derived biotherapeutics.

Frequently, two polishing steps are used to remove the remaining impurities and product variants/aggregates ^[14]. Resin- or membrane-based chromatography (ion exchange or hydrophobic interaction chromatography) is frequently used. The polishing steps remove impurities such as DNA, host cell proteins (HCP), and product aggregates ^[2]. Typically, all streams and buffers which enter the purification process are passed through sterilizing grade (0.22 μm pore size) filters to reduce bioburden. As shown in Figure 1, the virus filtration step is typically located near the end of the purification train. The product is relatively concentrated and highly purified. High product concentrations can lead to compromised performance due to product aggregation and increased adsorption to the virus filter membrane. A final ultrafiltration/diafiltration step is used to concentrate the product and place it in the formulation buffer needed for stability during shipping/storage and delivery to the patient. The final 0.22 µm pore size filter is used to ensure sterility of the product and is often part of the final fill-finish operation.

2.2. Viruses, Virus Clearance, and Virus Filters

Many mammalian cell lines produce endogenous retrovirus-like particles

Pseudorabies virus (PRV,

Herpesviridae

, enveloped DNA virus)

120–200

Adventitious virus contamination is a concern in the manufacture of biologics. Validation of virus clearance is shown by conducting scale-down testing ^[20]. The feed is spiked with model virus particles, and clearance in the product stream is determined. Minute virus of mice (MVM, mouse parvovirus) is often used to validate adventitious virus clearance. The FDA requires at least two orthogonal steps with different mechanisms of action for validation of virus clearance with the required level of virus clearance for the process as a whole, determined by summing the clearances obtained from the individual unit operations ^[2]. Virus filtration uses porous polymeric membranes in normal flow mode ^[15][21][22]. The predominant mechanism of action for virus filters is size exclusion ^[15]. The difference in hydrodynamic diameter between a protein product and MVM is often less than two-fold ^[5]. Today, virus filters are a critical component of the overall virus clearance strategy ^[15]. As shown in Table 3, virus filter membranes are typically made of regenerated cellulose, polyvinylidene difluoride (PVDF), and polyethersulfone. The latter two materials are hydrophilized in order to minimize fouling by adsorption and maximize flux during virus filtration. While the membrane should be biocompatible, non-fouling, and minimize adsorption on the membrane surface, it is also essential that the membrane is robust and dimensionally stable to ensure the required level of virus clearance.

Table 3. Commercially available virus filters ^[2][23][24]. Asahi Kasei Bioprocess is a part of the Asahi Kasei Group; MilliporeSigma is a subsidiary of Merck KGaA.

Filter	Manufacturer	Membrane Material	Configuration	Comments
Planova 15 N, 20 N	Asahi Kasei Bioprocess	Regenerated cellulose	Asymmetric single-layer hollow fibers	Parvovirus filter
Planova 35 N	Asahi Kasei Bioprocess	Regenerated cellulose	Asymmetric single-layer hollow fibers	Retrovirus filter
Planova BioEX	Asahi Kasei Bioprocess	Hydrophilized PVDF	Asymmetric single-layer hollow fibers	Parvovirus filter
Viresolve NFR	MilliporeSigma	Polyethersulfone	Asymmetric triple-layer pleated sheets	Retrovirus filter
Viresolve Pro	MilliporeSigma	Polyethersulfone	Asymmetric double-layer flat sheets	Parvovirus filter
Pegasus SV4	Pall Corporation	Hydrophilized PVDF	Symmetric double-layer pleated sheets	Parvovirus filter
Pegasus Prime	Pall Corporation	Polyethersulfone	Pleated sheets	Parvovirus filter
Ultipor VF DV20	Pall Corporation	Hydrophilized PVDF	Symmetric double-layer pleated sheets	Parvovirus filter
Ultipor VF DV50	Pall Corporation	Hydrophilized PVDF	Symmetric double-layer pleated sheets	Retrovirus filter
Virosart HC	Sartorius AG	Polyethersulfone	Asymmetric double-layer pleated sheets	Parvovirus filter
Virosart HF	Sartorius AG	Modified polyethersulfone	Asymmetric single-layer hollow fibers	Parvovirus filter

These virus filters are designed to ensure that only monomeric biomolecules with a hydrodynamic diameter less than 20 nm can pass through the pores. Much research is needed to understand how a multidomain, anisotropic mAb with varied surface moieties interacts with virus filtration membranes, prefilters, and other product monomers ^[25]. Table 3 is a non-exhaustive list showing commercially available virus filters and material configurations. Operating pressures and permeate fluxes vary greatly. Virus filter membrane fouling is a significant challenge ^[22][26][27]. Fouling can compromise virus clearance and reduce membrane productivity (product recovered per membrane surface area) ^[28]. Fouling is often due to product variants because of the high product purity before virus filtration and the high product concentration compared to the spiked virus concentration ^[2]. Recent studies focusing on virus filtration of mAbs showed that membrane performance depends on the mAb properties (pI, hydrophobicity, net charge, dipole moment, oligomericity), buffer conditions, membrane material, and operating pressure ^[22][29]. Buffer excipients such as arginine and lysine can stabilize mAbs and reduce fouling propensities ^[30]. Excipients such as histidine, arginine, and lysine can reduce reversible self-association of mAbs to varying degrees ^[31]. Reversible self-association is often concentration-dependent ^[31].