In Europe, the EURATOM Basic Safety Standards, which were published in 2013, include binding requirements (to be implemented into national legislation) for protecting against indoor radon exposure at work, home, and in the manufacturing and use of building materials [
Surveys can be classified according to their design characteristics. Among the criteria are their objectives (assessments of geographical or demographic means, i.e., means per area unit or per person living in an area, which are generally different), their coverage (which part of a country does a survey cover, distinguishing between local, regional, and national surveys), and the degree of representativeness. The latter indicates whether derived statistics, such as the empirical mean, can be assumed to coincide with the respective true value of the sampled quantity.
4. Identification of Problems
As previously shown in
Table 4, the results of indoor radon measurements in some Asian countries are relatively old, dating back to the late 1980s and early 1990s. In this case,
wthree
canproblems can be recognize
three problemsd.
4.1. Bias Due to the Thoron Interference
The first problem involves the quality assurance of results due to old types of detectors, i.e., bare detectors, and/or thoron influence. The problem was widely discussed by Tokonami
[151][55]. It was concluded that some old detectors have a high sensitivity to thoron, while others have a low sensitivity. It should be noted that the influence of thoron may be large if the detector is placed near the wall, even when low-sensitive detectors are used. As a consequence, the calculated annual dose can be overestimated.
4.2. Tendency toward “Green” Construction
The second problem is connected to the house construction. Modern technology and trends toward low, “green”, energy houses can lead to tighter dwellings and reduced natural ventilation. Recent studies from Russia have shown an increasing trend of radon levels in buildings ranked with high energy efficiency indices
[152][56]. In contrast to this, the results presented by McCarron
[153][57] support the hypothesis that certified passive house buildings present lower radon levels.
4.3. Survey Design and Evaluation
In many papers reporting on the means of regional surveys, the ’sample representatives’ issue is poorly (or not at all) discussed. Deviations from representative sampling can introduce biases in statistics, such as the mean, which renders the results questionable. See IAEA (2013), Section 3 of that report
[154][58], and European Commission (2019), Section 2.4.5
[42] of that report, for further discussions of this very important subject. Moreover, the reporting of results that meet statistical standards is sometimes suboptimal, and uncertainty budgets are rarely addressed. In order to deliver reasonable results that can be internationally recognized, it is important to employ certified and QA-ed procedures, including calibration, sampling designs, individual measurements, and statistical evaluation. In many papers, QA is poorly reported.
5. Recent Developments
5.1. Thoron
In some regions of the world, thoron and its progeny contribute more to radiation doses than radon
[84,155,156][59][60][61]. Kanse et al.
[157][62] worked on developing a method that uses the exhalation rate of Tn from indoor surfaces as the basis for estimating the average concentration of Tn in indoor air. Taking this thoron concentration and appropriate conversion factors into account, the inhalation dose can be calculated.
5.2. Calibration Chambers
Karunakara et al. presented an innovative technique of using soil gas as a source of radon in a calibration chamber
[158][63]. Constant radon concentrations in the range of 0.5–31 Bq m
−3
with a deviation of 5–15% were obtained by periodically injecting soil gas into the chamber. The time needed to obtain stable conditions is approximately 30–120 min depending on the required concentration.
As mentioned in
Section 2, some Asian countries have (or will introduce) regulations on radon concentration levels in residential buildings and workplaces. For this purpose, measurements should be made and maintained; for the results to be reliable, the measurement systems must be checked and validated periodically. One method of maintaining quality is to conduct intercomparison tests. Janik et al.
[159][64] presented the results of an experiment conducted in five radon and thoron measurement systems located in four Asian countries (China, India, Japan, and Thailand). They obtained good results when comparing the radon systems (chambers). Deviations from the average concentrations did not exceed 5%. They also showed that the systems for testing and calibrating thoron devices still require further research.
5.3. New Detectors
One method of dividing radon detectors is to distinguish between passive detectors that integrate radon (e.g., SSNTD, active carbon, electret) and active detectors that measure radon continuously, based on, e.g., semiconductors, PIN photodiodes, etc.
[160,161][65][66]
Although these detectors are used successfully, new methods are being developed and tested. One example involves a new detector presented by Hassanpur et al.
[162][67]. They explored the possibility of alpha spectroscopy in detecting radon and its progeny using a microstrip gas detector. Experiment data were validated by using a MCNPX code and the spectrum from the microstrip detector was compared to the one obtained by the Atmos device. Results showed that the microstrip detector can measure radon and its progeny and it has the ability to extract the spectrum obtained from it.
Another gas-type detector, a micropattern gas detector (MPGD), was tested in order to measure radon and progeny
[163][68].
Another example of the development of measurement techniques and methods is the system for measuring radon in the soil, as presented by Wang
[164][69]. One of the challenges in measuring radon in soil is that moisture interferes with the results. The presented system attempts to avoid this problem by using a suitable waterproof membrane and a calculation algorithm.
5.4. Soil Radon as Tracer
A topic widely discussed in recent publications is the relationship between radon in soil and geohazard research. As a recent example, the purpose of the study presented by Ma et al.
[165][70] was to show the mechanism that generates soil Rn anomalies by means of studying the geochemical behaviors of radionuclides in karst environments. They confirmed higher soil radon concentrations in karst compared to non-karst areas. They also found a significant positive correlation between Ra and MnO
2
(R2 (R2
= 0.86), which implied that Ra mainly occurred in manganese oxide minerals.
5.5. Advanced Data Preprocessing and Evaluation
One important topic in the collection and interpretation of data, which mainly applies to active detectors, is imputation. Mir et al. presented a new imputation methodology (by feature importance) to generate an imputed dataset when dealing with soil gas radon concentration time series data. This approach provides more accurate mean value predictions
[21].
A study by Rafique et al
[166][71] investigated the complexity of radon, thoron, temperature, and a relative humidity time series via entropy, along with fractal dimension analysis techniques. Their results showed that the dependence and complexity of the time series data of soil gases are greater in the winter than in the summer.
5.6. Radon Awareness and Risk Communication
In addition to measuring radon and assessing the dose, increasing radon awareness and communication are very important tasks. Based on the survey results, it was concluded that the level of radon awareness among the people of Bahrain is low, with only 32.6% being aware of radon and its health hazards
[167][72].
5.7. Radon Therapy
Currently, radon is being explored as an additional method of treatment for various diseases related to the respiratory system, pain, or rheumatism.
Review studies on radon therapy were compiled and presented by authors in Japan
[168][73]. A comparison of the published research results shows that active oxygen in combination with radon gas has great potential in suppressing disorders and various types of diseases.